Cold at the top: air
If the radiator is warm at the bottom and cold across the top, there is air trapped inside. Bleed it with a radiator key at the bleed valve at the top of the radiator, with a cloth underneath. You will hear a hiss of air, then water, and then you close it.
If air keeps coming back, air is being drawn into the system somewhere, which usually means the system needs attention rather than more bleeding.
Cold at the bottom: sludge
Warm at the top and cold at the bottom means debris has settled inside the radiator. This is very common in older systems, and it is the reason radiators sometimes feel warm at the top and stone cold along the bottom edge.
A single affected radiator can often be flushed individually. If several are the same, the whole system needs a proper clean and fresh inhibitor, otherwise the sludge will keep settling.
Cold all over, while others are hot
- A stuck thermostatic valve pin. The pin inside a TRV seizes in summer and never opens again. Removing the head and freeing the pin often brings the radiator straight back to life.
- A closed valve. Check both ends — a lockshield that has been turned down too far will starve the radiator completely.
- The system is out of balance. If one radiator takes all the flow, others downstream stay cold. Balancing sets each radiator to take its share.
Cold all over, with every radiator cold
If nothing is heating, the problem is the system rather than a radiator: no demand, a pump not running, low pressure, or air at the highest point. That is a heating system fault rather than a radiator fault, and it is worth a proper look rather than guesswork.
A quick check that costs nothing: make sure the thermostat is calling for heat, and check the boiler pressure gauge. Low pressure is a common and simple cause.
What we do about it
We diagnose which of the above it is before touching anything, then replace or repair what has actually failed: valves, TRV pins, radiator tails. We refill and bleed the system and balance it so the heat is spread properly rather than pooling in the rooms nearest the boiler.
If a radiator needs to come off for decorating or flooring, we can drain, remove and refit it, then check for leaks and bleed it afterwards.
Should I bleed my radiators every year?
Before the heating season starts, yes — it is a five-minute job and it makes a noticeable difference. If air returns within weeks, the system needs investigating rather than more bleeding.
Can I fit a new radiator myself?
You can, but getting the sizing and the balancing right matters more than the fitting. An oversized radiator on an unbalanced system just makes the nearest rooms hotter.
Do you repair radiators or only replace them?
Repair wherever possible. Valves, TRVs and tails are all replaceable, and flushing usually rescues a radiator that is full of sludge. Replacement is the last resort, not the first.