First, work out what kind of tap you have
There are three common types in Reading homes, and they fail in different ways.
- Traditional pillar taps (separate hot and cold, often older): usually a rubber washer at the end of a jumper, or a worn valve seat.
- Ceramic disc taps (a quarter turn from off to full): the ceramic discs inside have worn or cracked.
- Modern mixer and monobloc taps: a cartridge inside the body has failed — this is by far the most common cause of dripping in hard-water areas.
Turn the water off and isolate the tap
Close the internal stopcock, then open the tap you are working on to release the pressure. If there is an isolation valve on the tap supply — a small screwdriver slot or lever on the pipe underneath — close that instead, so the rest of the house keeps its water.
Put the plug in the sink before you start. Small screws and washers disappear down the waste very easily.
Dismantle and replace the worn part
On a traditional tap, lift off the index cap (often marked H or C), unscrew the head, then undo the retaining nut and lift out the jumper or valve. Take the washer or the whole jumper to a plumber’s merchant and match it — a washer costs pence and a cartridge a few pounds.
On a mixer or monobloc, remove the handle screw and handle, then unscrew the retaining ring and pull the cartridge. The cartridge is specific to the tap, so note the brand or take the old one with you. Many manufacturers still supply them even for taps that are years old.
If it still drips after the repair
On older taps the valve seat inside the body can be pitted, so a new washer stops the drip for a week and then it returns. That needs re-cutting or the tap replacing.
In Reading the other common culprit is limescale. Hard water builds a crust on cartridges and seats, and simply cleaning that off sometimes restores a tap that seemed finished. If scale is recurring, the cartridge is usually too far gone and replacement is the sensible answer.
When it is worth calling a plumber instead
Call us if the tap will not come apart, if the isolation valve will not close, if the tap body is corroded, or if the tap is a concealed or expensive model you would rather not risk. We replace cartridges, discs and washers with matched parts, and we check the waste and trap while the cupboard is empty.
A tap that drips into a worktop or down the back of a unit also causes damage out of all proportion to the drip itself — a slow leak behind a cupboard can rot a base unit before anyone notices.
How much water does a dripping tap waste?
A steady drip can waste well over a litre an hour, and a slow trickle far more. On a metered supply you are paying for every drop, and on any supply you are paying to heat it if it is the hot tap.
Can I fix a dripping tap without turning the water off?
Only if there is a working isolation valve on that tap’s supply. If there is not, close the internal stopcock. Trying to swap a cartridge on a live supply means water everywhere.
Do you fit taps I have bought myself?
Yes. We will fit a tap you have supplied, or source a matching replacement if the original model has been discontinued.